How to throw on the wheel

Nine steps, seen from the inside.

Every pot on the wheel goes through the same steps. What changes is the shape of the clay at each one. Pick what you are making, pick something to compare it with, and scroll. The diagram is the pot sliced down the middle.

Hand positions are written for right-handers on a wheel turning counter-clockwise. Swap them if you throw the other way.

Making
Versus
4 in4¼ in

1. Wedge it and slam it down

  1. 01Wheel: Slow

    Wedge it and slam it down

    Wedge the clay to push out air and even up the moisture, pat it into a ball, and throw it down on the dry wheel head as close to the middle as you can. Pat it into a rough cone with the wheel turning slowly, then seal the bottom edge to the wheel with a fingertip.

    For a bowl4 in wide × 3¾ in tall

    About 2 lb makes a cereal-size bowl.

    For a bottle4¼ in wide × 4¼ in tall

    About 2½ lb, same as the vase.

    Hand positions
    LRYOU SIT HERE
    Pat and seal
    Best for: Everyone
    L
    Cups one side of the ball and pats it toward the middle.
    R
    Cups the other side. Both hands pat in time as the wheel creeps round.

    What you should feel: A firm thud when it lands. Push it sideways: it should not rock or slide.

    Watch for: A wet wheel head. The ball will slide instead of sticking.

  2. 02Wheel: Fast

    Cone it up

    Wet the clay. Push the left hand away from you and pull the right hand back toward you, squeezing the clay between them, and let it rise into a tall cone. Then push it back down with the heel of one hand on top while the other hand steadies the side. Do this two or three times. Coning lines up the clay so the whole lump runs true.

    For a bowl3¾ in wide × 5½ in tall

    Same coning as any other pot. Two or three trips up and down.

    For a bottle4 in wide × 6 in tall

    Cone it well. Any wobble left in the clay shows up when you collar the neck.

    Hand positions
    LRYOU SIT HERE
    Push and pull
    Best for: The strong way. Start here.
    L
    Heel of the palm on the near-left side of the clay, pushing away from you.
    R
    Fingers wrapped round the far side, pulling back toward you. The two hands squeeze the clay between them and it rises.

    What you should feel: Clay rising between your palms, like toothpaste out of a tube.

    Watch for: A hollow dimple at the top of the cone. Push it down from the side of the tip, not straight on top, or you will trap air.

  3. 03Wheel: Fast

    Center into a puck

    Bring the cone down into a puck. Brace your elbows on your thighs. One hand pushes in on the side, the other presses down on top, and you hold still until the clay stops bumping your hands. This is where forms start to differ: the width of this puck is decided by what you are making.

    For a bowl5½ in wide × 1½ in tall

    Press it low and wide. A bowl wants a broad base to grow out of.

    For a bottle4 in wide × 3 in tall

    The narrowest, tallest puck of the lot. Almost as tall as it is wide.

    Hand positions
    LRYOU SIT HERE
    Heel and blade
    Best for: The standard. Start here.
    L
    Heel of the palm on the side at 8 or 9 o’clock, elbow locked into your hip. This hand does not move.
    R
    The edge of the hand, like a karate chop, flat on top. Thumb hooked over the left hand.

    What you should feel: Nothing at all. When the clay stops nudging your hands, it is centered.

    Watch for: Letting go fast. Ease your hands away slowly, or you will knock it right back off center.

  4. 04Wheel: Medium

    Open

    Also called drilling down

    Find the middle with your thumbs or two fingers and press straight down. Some potters call this drilling down. Stop before you reach the wheel head. Stop the wheel and check the floor with a needle tool if you are not sure how much is left.

    For a bowl5½ in wide × 1½ in tall

    Stop early. Leave a thick floor (about ½ in) so there is clay to trim a foot ring from later.

    For a bottle4 in wide × 3 in tall

    Open down to about ¼ in.

    Hand positions
    LRLYOU SIT HERE
    Two thumbs
    Best for: Small pots, mugs
    L
    Fingers wrap the outside. Thumb goes down the middle.
    R
    Same. Both thumbs press down together, side by side.

    What you should feel: A smooth drill. If your finger is being pushed in a circle, the hole is off center.

    Watch for: Going through the bottom. It happens to everyone exactly once.

  5. 05Wheel: Medium

    Widen and compress the floor

    Pull your fingers from the center toward your body to widen the hole into a floor. Then press back and forth across the floor a few times with fingertips or a rib. Compressing packs the clay down so the bottom does not crack as it dries.

    For a bowl5½ in wide × 1¾ in tall

    Do not make a flat floor. Sweep your fingers up as you move out so the floor is already a curve.

    For a bottle4 in wide × 3 in tall

    Barely widen. The base of a bottle is small.

    Hand positions
    LRYOU SIT HERE
    Toward 3 o’clock
    Best for: The standard
    L
    Stays on the outside wall at 3 o’clock and stops it growing.
    R
    Fingertips hook the floor at the centre and draw straight out to 3 o’clock.

    What you should feel: A flat floor under your fingertips. Any ridge or dip means one more pass.

    Watch for: S-shaped cracks in the bottom a week later. They come from skipping the compressing.

  6. 06Wheel: Slow

    First pull

    Slow the wheel. One hand inside, one outside, fingertips opposite each other at the very bottom. Squeeze in gently to make a small bump of clay, then carry that bump all the way up at a steady pace. Ease off just before the rim.

    For a bowl6½ in wide × 2¾ in tall

    Pull mostly up, letting the top lean out a little. You are starting a trumpet, not a bowl yet. Keep the rim thicker than you think.

    For a bottle3¾ in wide × 4¾ in tall

    Pull up and keep the top slightly narrower than the base. A cone shape resists flaring.

    Hand positions
    LRYOU SIT HERE
    Fingertips
    Best for: Small pots. The most feel.
    L
    Inside at 3 o’clock, fingertips pressed into the bottom corner.
    R
    Outside at 3 o’clock, fingertips just below the left hand’s. Thumbs touch to link the hands.

    What you should feel: A small roll of clay riding up just above your fingers.

    Watch for: Moving up faster than the wheel turns. You get a spiral, and then a wobble.

  7. 07Wheel: Slow

    Pull to height

    Repeat, two or three more pulls. Each one starts at the floor and goes all the way to the rim. Compress the rim with a fingertip after every pull to keep it strong and level. Sponge water out of the bottom as you go.

    For a bowl7¾ in wide × 3½ in tall

    Pull a trumpet: nearly upright at the bottom, flaring toward the rim. The bowl curve comes in the next step.

    For a bottle3½ in wide × 7½ in tall

    As tall as you can get it while it still stands true. This is the hardest step.

    Hand positions
    LRYOU SIT HERE
    Fingertips
    Best for: Small pots. The most feel.
    L
    Inside at 3 o’clock, fingertips pressed into the bottom corner.
    R
    Outside at 3 o’clock, fingertips just below the left hand’s. Thumbs touch to link the hands.

    What you should feel: Pinch the wall low, middle and high. All three should feel the same.

    Watch for: A thick ring left at the base and a paper-thin rim. Start the pull lower than feels natural.

  8. 08Wheel: Slow

    Shape

    Now the cylinder becomes something. Press out from the inside to swell the form while the outside hand or a rib guides the curve. Work from the bottom up, lightly, in more than one pass.

    For a bowl9½ in wide × 3 in tall

    Now open the trumpet into a bowl. Hold a curved rib inside and press out while the wheel turns. One smooth curve, floor to rim.

    For a bottle4¾ in wide × 7¾ in tall

    Push out the belly, and start leaning the shoulder inward.

    Hand positions
    LRYOU SIT HERE
    Fingers and rib
    Best for: Bowls and bellies
    L
    Inside at 3 o’clock, pushing out where the form should swell.
    R
    Outside, holding a rib against the wall just above the inside fingers.

    What you should feel: The wall moving, not thinning. If it starts to feel thin, stop.

    Watch for: Shaping before you have the height. Once the wall is curved out, it is very hard to pull any taller.

  9. 09Wheel: Slow

    Finish and wire off

    Collar in a neck if the form has one, and refine the rim with a sponge or a strip of chamois. Cut a bevel under the base with your wooden knife, mop the last water out of the inside, then pull your wire flat under the pot and lift it off with dry hands.

    For a bowl9¾ in wide × 3 in tall

    Compress the rim, then undercut the base with your wooden knife. The extra clay there becomes the foot.

    For a bottle5 in wide × 8½ in tall

    Collar in small squeezes, wheel a bit faster. Pull the neck up after each squeeze because collaring thickens the wall.

    Hand positions
    LLRRYOU SIT HERE
    Collar, six points
    Best for: Necks on bottles and vases
    L
    Thumb, index and middle finger touch the clay on the left side.
    R
    The same three on the right, so six points circle the form. Squeeze gently and rise.

    What you should feel: A rounded rim, slightly thicker than the wall below it.

    Watch for: Water left sitting inside. It soaks into the floor and cracks it.

  10. Did it come out wrong?

    Good. Cut it in half and find out which step did it.

    Troubleshoot a pot →