Handbuilding

No wheel. Three ways to build.

Pinch, coil and slab are the three ways to make a pot with your hands and a table. Pick one and scroll. The diagram is the pot sliced down the middle, the same as on the throwing page.

Method
2½ in

1. Roll a ball

  1. Pinch pot

    The oldest way to make a pot, and the best way to learn how thick a wall should feel.

    Clay: ¾ lb · You need: Your hands

  2. 01

    Roll a ball

    Pat a piece of clay about the size of a small orange into a smooth ball. Close any cracks or folds now. Every crack you leave in the ball shows up later in the rim.

    Your hands
    Roll it between both palms, then pat it round.
    Size at this step
    2½ in wide × 2½ in tall

    Watch for: Clay that is too dry. If the ball cracks as you roll it, wedge in a little water.

  3. 02

    Press your thumb in

    Hold the ball in one hand and push the thumb of the other straight down into the middle. Stop when there is about a finger’s width of clay left at the bottom.

    Your hands
    The ball sits in your cupped palm. The other thumb does the pressing.
    Size at this step
    2½ in wide × 2½ in tall

    Watch for: Going through the bottom. Pinch the base between thumb and finger to feel how much is left.

  4. 03

    Pinch and turn, from the bottom

    With your thumb inside and fingers outside, pinch gently and turn the ball a little. Pinch, turn, pinch, turn. Work around the bottom first, in a spiral, and leave the rim thick.

    Your hands
    Thumb inside, fingers flat outside. Small, even squeezes, all the same strength.
    Size at this step
    3 in wide × 2½ in tall

    Watch for: Thinning the rim first. It flares, cracks, and you can never bring it back in.

  5. 04

    Thin the wall upward

    Keep spiralling up the wall. Each round of pinches sits just above the last. The pot opens and grows as the wall thins. Aim for the thickness of a pencil all the way up.

    Your hands
    Feel the wall between thumb and fingertips. Go back to anywhere that feels thicker.
    Size at this step
    3½ in wide × 2¾ in tall

    Watch for: Cracks at the rim. Smooth them shut with a damp fingertip as soon as they appear.

  6. 05

    Shape it and flatten the base

    Tap the pot gently on the table to give it a flat base to stand on. Smooth the outside with a rib or the back of a spoon, and round the rim with a damp fingertip.

    Your hands
    One hand cups the pot from inside while the other smooths the outside.
    Size at this step
    3¾ in wide × 2¾ in tall

    Watch for: Too much water. Handbuilt pots need almost none. A wet pinch pot slumps.