Troubleshooting

Cut it in half.

The fastest way to improve is to slice a pot down the middle with your wire and look. The cross section shows exactly which step went wrong. Here are the six you are most likely to find, each drawn against the cylinder you were aiming for.

What you made What you were aiming for

Went wrong at: First pull

Heavy bottom, thin top

What you see
The wall is a wedge: thick as a thumb at the base and paper-thin at the rim. The pot feels like a brick.
Why it happened
Your pulls started too high, so the clay in the bottom corner never moved. Every pull thinned only the top half.
Next time
Start each pull with your fingertips pressed right into the corner where wall meets floor. Squeeze there first, then travel up.

How to cut a pot in half

  1. 1

    Stop the wheel. Leave the pot where it is, still stuck to the wheel head.

  2. 2

    Hold your wire tight above the rim, across the middle, and press straight down to the wheel head.

  3. 3

    Lift one half away and look at the cut face. Then wedge both halves and throw it again.

Back to the nine steps โ†’